PARTS

• Riser

• Top limb *marked with draw weight*

• Bottom limb *marked with bow model*

• Limb bolt set

• Bow string

• Stringer

ASSEMBLING YOUR BOW

• Press limbs into riser pins, then bolt into place until firmly secure (don’t over-tighten)

• Pull the larger loop of the bow string over the top limb and down the belly, then hook the smaller loop into the string groove on the bottom limb

• Place the pocket of the stringer on the bottom limb with the open end facing up, then wrap the looped end of the stringer around the top limb and lie the rubber saddle flat on the back of the limb below the big loop of the bow string

• With the limb tips facing up, push the saddle up the limb so that the string is taught against the belly of the limbs, then step onto center of the stringer and pull directly up on the riser applying steady pressure (do NOT twist the limbs!) until you’re able to slide the larger loop into place in the top string groove (ensure the string is securely nested within the string grooves before releasing pressure from the stringer)

DISASSEMBLING YOUR BOW

• With the limb tips facing up, replace the pocket of the stringer on the bottom limb and position the saddle approximately ⅓ the length of the limb below the tip

• Step back onto the center of the stringer and apply steady pressure until you’re able to slide the big loop back down the belly of the top limb (relieve pressure slowly to avoid twisting limbs)

• Remove the string and limb bolts and stow somewhere safe